I have a Omni ProII installed when I built in 2005. Never had any issues until the last 2 weeks. Keypads in the middle of the night randomly started chirping no controller data. Checked battery and it was no good so I replaced it. Voltage is good on battery but if I unplug the wall plug it still doesn't stay up running.
Also the network lights sometimes stay on solid sometimes flash rapidly and sometimes don't come on at all. I shut it all down for a couple days then try it again and it may run for a couple days then start acting up again. I have one mounted expansion board and in pc access it shows comm stat as bad and battery as 0. Do I need to just send it in?
Another strange thing is I have disconnected everything on the Omni ProII and only connected 1 keypad and battery, did the console test and sometimes it works and sometimes it don't. Did the same thing to the Omni IIe with the same console and it seems to work on the console all the time. Does it sound like a flaky comm board?
Second question is I have a Omni IIe board, would I be able to install this one in the meantime while my other one is being repaired? I'm in Canada so its a real pain to send away.
Also the network lights sometimes stay on solid sometimes flash rapidly and sometimes don't come on at all. I shut it all down for a couple days then try it again and it may run for a couple days then start acting up again. I have one mounted expansion board and in pc access it shows comm stat as bad and battery as 0. Do I need to just send it in?
Another strange thing is I have disconnected everything on the Omni ProII and only connected 1 keypad and battery, did the console test and sometimes it works and sometimes it don't. Did the same thing to the Omni IIe with the same console and it seems to work on the console all the time. Does it sound like a flaky comm board?
Second question is I have a Omni IIe board, would I be able to install this one in the meantime while my other one is being repaired? I'm in Canada so its a real pain to send away.