I have recently replaced a z-wave lock that failed. I am unable to get the lock status to show correctly on the Omnipro. I have 2 Kwikset lever locks and one Kwikset deadbolt. None of the locks show the correct status. The one lever lock shows locked all the time. I can run the unlock command (via Haiku) and the lock will unlock but it still shows locked on the Haiku app and the web interface. I also tried PC access and it shows the same that the lock is always in the lock state. The deadbolt is the same way it always shows locked. I created a buttons to send the lock and unlock commands (regardless of the state of the lock) and I can both lock and unlock the deadbolt, But it still shows that it is locked. I have verified that the batteries are good, but the main status LED is flashing red.
Help, I have deleted the entire setup and re-included all the z-wave devices and associated them with the Vizia RF+ serial module and it still does not work. I have installed brand new batteries in the one lock with no effect. I do see the Red led (next to the include button) turn red when the lock changes state. I am using the Leviton RF+ installer tool V 1.1.2.0 to program the network.
Help, I have deleted the entire setup and re-included all the z-wave devices and associated them with the Vizia RF+ serial module and it still does not work. I have installed brand new batteries in the one lock with no effect. I do see the Red led (next to the include button) turn red when the lock changes state. I am using the Leviton RF+ installer tool V 1.1.2.0 to program the network.