me2
Member
Today I installed a second m1dbh in a remote (away from M1 panel) area about 70+/-Ft. from the M1. Then I attached a new m1xin to the new m1dbh. The address of the m1xin was set to 13, zones 193-208. I jumpered JP1 = no. The m1xin is plugged into the first position of the new m1dbh and the terminator is in the next position. The m1xin enrolled without any problem. I defined zones 193 and 195 as Burglar Perimeter Instant and Normally Closed. Shorted each of them with a wire.
When I watch them on the Current Status page of Elkrp they are both toggleing from normal (Short (-)) to violated (open (+)). I rechecked my work for loose connections etc. without finding anything.
Also the DB led on the m1xin is flashing at about a rate of a second.
Anyone have a idea what I have done wrong? And what does the status of the leds on m1xin mean?
When I watch them on the Current Status page of Elkrp they are both toggleing from normal (Short (-)) to violated (open (+)). I rechecked my work for loose connections etc. without finding anything.
Also the DB led on the m1xin is flashing at about a rate of a second.
Anyone have a idea what I have done wrong? And what does the status of the leds on m1xin mean?