wdeertz
Active Member
I am using an OmniPro2 with two wireless 45A00-1 receivers. #1 wireless receiver is programmed as A1/n1 (using zones 49-112) and #2 wireless receiver is A5/n1 (using zones 113-128). I have PC Access configured for 5 expansion enclosures eventhough I am using less than 16 zones on each individual receiver. While in the PC Access status page I get "Bad" readings for enclosures #2-#4 (see attached file) which I suspect is because I am not using any zones within these ranges.
I've looked at the 45A00-1 documentation and am not sure if its possible to have #1 wireless receiver only use zones 49-64 and #2 wireless receiver only use zones 65-80 and configure as only 2 expansion enclosures. I don't anticipate ever having more than 16 wireless devices on either receiver so reconfiguring in the future for zones 49-112 shouldn't be an issue.
I don't seem to be having any issues with the OP2 but the "Bad" readings on enclosures #2-#4 doesn't seem right.
Can anyone shed light on how I can change my setup to eliminate these "Bad" readings?
I've looked at the 45A00-1 documentation and am not sure if its possible to have #1 wireless receiver only use zones 49-64 and #2 wireless receiver only use zones 65-80 and configure as only 2 expansion enclosures. I don't anticipate ever having more than 16 wireless devices on either receiver so reconfiguring in the future for zones 49-112 shouldn't be an issue.
I don't seem to be having any issues with the OP2 but the "Bad" readings on enclosures #2-#4 doesn't seem right.
Can anyone shed light on how I can change my setup to eliminate these "Bad" readings?