Bzncrewjr
Active Member
I found one of my zones hardwired contacts are faulty. Somewhere in the wall likely someone (sheetrockers?) may have cut it, maybe it was me.
Is there a simple wireless-to-wired solution I can replace this zone with? All the other hardwired zones are fine, it's just this one zone, and Murphy's law is the zone where I have the least amount of access to replace the wire. One zone, I'd rather not spend a lot of money on complex modules for a single zone. If there was a way to convert a wireless to hardwired contact back at the panel it would solve my problem.
And is there a simple troubleshooting method to test the wire? I'm assuming I'm screwed on the hardwire and can't fix it.
--Russ
Is there a simple wireless-to-wired solution I can replace this zone with? All the other hardwired zones are fine, it's just this one zone, and Murphy's law is the zone where I have the least amount of access to replace the wire. One zone, I'd rather not spend a lot of money on complex modules for a single zone. If there was a way to convert a wireless to hardwired contact back at the panel it would solve my problem.
And is there a simple troubleshooting method to test the wire? I'm assuming I'm screwed on the hardwire and can't fix it.
--Russ