I have an HAI OmniPro II and am trying to connect it to a ZWave network using a VRC0P bridge. My primary controller is an Aeon Labs Z-Stick. I am able to include modules into the network with this stick and control them successfully using the ZTool software. However, how are you supposed to include the VRC0P and set it up for connection to the HAI?
- I tried following the same stand-alone inclusion process with the VRC0P using the Z-Stickas the normal switch modules and it acts differently, not sure what it is doing.
- I tried the "Add Device" button in ZTool, but I get a "ADD_NODE_STATUS_FAILED" when pressing the button on the VRC0P.. I also tried a factory reset on the VRC0P but that didn't help.
- There is a "Create Secondary" button in the ZTool software, but it just sits there with the "REPLICATION_STARTED" status. I tried holding the VRC0P button down until it blinks amber, but nothing changes.