I have 15 HAI switches and three 6 button keypads. All UPB programmed control worked well for a few years and then a few became intermittent or quit accepting commands. I also have about twenty X10 devices and they have always worked from day 1.
I believe someone suggested some type of repeater to boost the UPB signal to noise.
Things tried:
replaced UPB power interface module
added HAI phase coupler
Tested for locally generated noise by turning all circuit breakers off except to test a single light circuit. That UPB switch was still inconsistent.
I want get everything working again . . is there a repeater or similar to boost the UPB signal ? This time I am going to do it.
If someone is an expert, you can remote into my dedicated HAI computer and will pay a reasonable fee. Maybe you could find Upstart useful . . I have never been able to figure it out and all my original installation was with manual setting up UPB devices.
Remember Web-Link includes email alert setup below. To access it I have an Oracle Virtual-Box running windows XP and the necessary ancient version of IE.
I believe someone suggested some type of repeater to boost the UPB signal to noise.
Things tried:
replaced UPB power interface module
added HAI phase coupler
Tested for locally generated noise by turning all circuit breakers off except to test a single light circuit. That UPB switch was still inconsistent.
I want get everything working again . . is there a repeater or similar to boost the UPB signal ? This time I am going to do it.
If someone is an expert, you can remote into my dedicated HAI computer and will pay a reasonable fee. Maybe you could find Upstart useful . . I have never been able to figure it out and all my original installation was with manual setting up UPB devices.
Remember Web-Link includes email alert setup below. To access it I have an Oracle Virtual-Box running windows XP and the necessary ancient version of IE.