I'm just getting started with Premise so forgive me if I'm missing something obvious.
I have a CT30 in my Z-Wave network. The device supports reporting the set point, current temp, fan & mode as well as manual/scheduled however Temperature and Set Point are not working in Premise.
I did some manual poking around in the terminal and noticed that when queried the tstat reports back in a format that varies from what I've found in Zensys documentation.
>N4SE49,4
<E000
<X000
<N004:049,005,001,042,002,248
So I read this as, Node 4, Command Class, Command Report, Value is Temp, ??? (Expecting 009), ???, ???
The last bit changes as the thermostat temp does... at approximately 3.2 * Fahrenheit value... So at 248, the thermostat itself read 76... at 233, 74.5 etc. As far as I know this isn't °F, °C, K, °r, or °R...
Any ideas?
I have a CT30 in my Z-Wave network. The device supports reporting the set point, current temp, fan & mode as well as manual/scheduled however Temperature and Set Point are not working in Premise.
I did some manual poking around in the terminal and noticed that when queried the tstat reports back in a format that varies from what I've found in Zensys documentation.
>N4SE49,4
<E000
<X000
<N004:049,005,001,042,002,248
So I read this as, Node 4, Command Class, Command Report, Value is Temp, ??? (Expecting 009), ???, ???
The last bit changes as the thermostat temp does... at approximately 3.2 * Fahrenheit value... So at 248, the thermostat itself read 76... at 233, 74.5 etc. As far as I know this isn't °F, °C, K, °r, or °R...
Any ideas?