pete_c
Guru
A while ago here made the VRC0P a secondary to the Z-Wave Razberry-Pi GPIO card.
The VRC0P is connected to the Leviton OmniPro 2 panel.
Currently I cannot see the Z-Wave node changes done by the VRC0P on the Razberry-Pi GPIO card and vice versa.
I can control all of the Z-Wave nodes fine with either the VRC0P (basement) and the Razberry-Pi GPIO card (attic).
I did notice while doing a Z-Wave node network scan with the Razberry-Pi GPIO card it picked up the VRC0P as a node with neighbors.
Does this mean that the primary Razberry-Pi GPIO card is using the secondary VRC0P as a transport medium for the neighbor Z-Wave nodes it sees?
The VRC0P is connected to the Leviton OmniPro 2 panel.
Currently I cannot see the Z-Wave node changes done by the VRC0P on the Razberry-Pi GPIO card and vice versa.
I can control all of the Z-Wave nodes fine with either the VRC0P (basement) and the Razberry-Pi GPIO card (attic).
I did notice while doing a Z-Wave node network scan with the Razberry-Pi GPIO card it picked up the VRC0P as a node with neighbors.
Does this mean that the primary Razberry-Pi GPIO card is using the secondary VRC0P as a transport medium for the neighbor Z-Wave nodes it sees?