I have an OPII that runs UPB for automation, to which I have added the following Z-Wave setup:
- Leviton VRC0P RF + 3 serial interface
- Leviton VRUSB Vizia RF + USB programmer
- Leviton Z-Wave lamp dimmer module associated to VRC0P
- Ecolink motion detector associated to VRC0P
- Aeon Labs door/window sensor associated to VRC0P
- Leviton VRCPG hand held remote programer.
I had no issues getting the lamp dimmer and door sensor to show up in PC Access, but after a lot of trial and error, I got the motion sensor to work with the OPII only when I additionally associated "Button 2" on the sensor with the VRC0P using the hand held programmer.
Questions:
- Am I missing something in setting up the motion sensor to work more intiutively with the OPII?
- I know the motion sensor puts out battery and tamper alerts. How can I get the OPII to read these?
- The door sensor puts out a tamper alert. How can I get the OPII to read this?
Thank for your patience with the long post. I'd appreciate any advice as this is my first DIY Z-Wave project.
- Leviton VRC0P RF + 3 serial interface
- Leviton VRUSB Vizia RF + USB programmer
- Leviton Z-Wave lamp dimmer module associated to VRC0P
- Ecolink motion detector associated to VRC0P
- Aeon Labs door/window sensor associated to VRC0P
- Leviton VRCPG hand held remote programer.
I had no issues getting the lamp dimmer and door sensor to show up in PC Access, but after a lot of trial and error, I got the motion sensor to work with the OPII only when I additionally associated "Button 2" on the sensor with the VRC0P using the hand held programmer.
Questions:
- Am I missing something in setting up the motion sensor to work more intiutively with the OPII?
- I know the motion sensor puts out battery and tamper alerts. How can I get the OPII to read these?
- The door sensor puts out a tamper alert. How can I get the OPII to read this?
Thank for your patience with the long post. I'd appreciate any advice as this is my first DIY Z-Wave project.