-
-
Aano replied to the thread Low priced TV's.I've had two Creality printers. One was the Creality CR-6 SE. It was a Kickstarter printer but I bought mine after Kickstarter. It never...
-
Aano replied to the thread Low priced TV's.I think it depends on what you are looking for. If you want cheap multicolor just for PLA, a Bambu Lab A1 or A1 mini is a good choice...
-
Aano replied to the thread MakerBot Replicator.If these are small, you will probably be OK, as they get bigger, then the problems will start.
-
Aano replied to the thread MakerBot Replicator.PEI isn't the greatest choice for an unheated bed, but there are some newer beds that work well with PLA on unheated beds, like the...
-
Aano replied to the thread Low priced TV's.I started 3D printing when someone here talked about it many years ago. Many 3D printers later, I now think I have 6 of them now.
-
Aano replied to the thread Hardware recommendations for push button control of hot water circulation pump.It depends on if you want the best way or the cheapest way, and how big the house is. There is an Autohot system made for this that is a...
-
Aano replied to the thread All HAI Software.What is "Snaplink for Widow?" Is that for when the home automation guy dies, his wife can still turn on the lights?? :)
-
AIf you have Wemo/Belkin switches/outlets that are NOT using HomeKit, they will stop functioning next January. I believe these are WiFi...
-
Aano replied to the thread Problem with 38A00-1 UPB 6-Button Scene Switches Inoperative.To fully reset to press the on and off for 3 seconds, like you are. All LEDs should blink. Then press the A and D for 3 seconds. Then...
-
-
Loading…
-
Loading…