-
-
Mmjs replied to the thread HAI OmniPro2 Ethernet Port Issues.I'm not by the panel now so can't send a photo, but I programmed the HAI controller via the panel. It sticks every time i change it so...
-
Mmjs replied to the thread HAI OmniPro2 Ethernet Port Issues.Thanks. I've tried all of the above and still not ping'able. I tested continuity of the cable all the way to the HAI board, and it's...
-
Mmjs replied to the thread HAI OmniPro2 Ethernet Port Issues.I just changed the DHCP IP pool to start at .4 and end at .249 because I was testing if the OP2's IP of 168.1.3 or xxxx.1.250 would...
-
-
Mmjs replied to the thread HAI OmniPro2 Ethernet Port Issues.... no luck. I tried xxx.xxx.1.3 and same result: "Destination host unreachable"
-
Mmjs replied to the thread HAI OmniPro2 Ethernet Port Issues.I'm new to networking but trying to learn, so appreciate your patience. My understanding based on some Google searches and ChatGPT is...
-
Mmjs replied to the thread HAI OmniPro2 Ethernet Port Issues.Hi Pete, I've read through many of these OmniPro II connectivity posts, trying to figure out why I cannot get Snap-Link to "see"/connect...
-
-
Loading…
-
Loading…
