Recent content by Armagedon

Is there any chance to reprogram the hobby-board's hub and make it all channels turned on by default? I would like to use it with Barix Barionet 100 controller, but I doubt that there is chance to modify Barionet firmware for supporting the 1-wire hub. Currently the Barionet can detect the hub...

Hello,   https://www.hobby-boards.com/store/products.php?product=4-Channel-Hub   Has anyone experience with this 1-wire hub? As I understood, it has 4 channels which need to be controlled by 1-wire master. By default the channels are turned off. This means, if a kind of PC based 1-wire software...

Hello PaulB. In my case the pump relay is now turning on and off simultaneously with loop control relay's. But the water loop switch (actuator) acctually is switching the water pipe on of off in 3-4 minutes. There is a kind of pressure protection pipe in the water distribution design, which...

Just one remark about HAI relay modules. This is ture that they are the best in fittin point of view in the HAI cabinet. The relay output connectors are also protected against overvoltage, but the design is for US voltage, 120V. If you want to use the HAI relay modules (at least those what US...

I'm using HAI temperature sensors with OmniPro II for controlling heated floors. One sensor for one room / loop. Temperature setpoints is possible to change via console or computer (SnapLink, Dealer PC Access software). I'm measuring air temperature in the room. OmniPro II outputs are...

Tank you very much, Desert_AIP ! It works!! You made my day.. :-)

Hello. I have radiant floor heating, controllerb by HAI OmniProII. 9 pipe loops in floor, with temperature sensors and controlled by outputs. This is working fine (switching on and off the loops). I also would like to control the heating water pump - switch it on if any of the 9 loops is...