Recent content by braddg

I set the two motion sensors that are in the cross zone pool to "Burglar Interior Night". This morning when the cats woke up and jumped off the top of the couch, the keypad stared buzzing. This time without the delay counter as before and, as intended, no alarm. It buzzed for about 10...

Yes, I am using an Elk M1G. I have been giving this some thought. I am thinking of changing my motion sensors to Instant (no delay). I originally set them up with a delay because I assumed someone getting up in the middle of the night might set off the alarm. So far this has not been a...

This morning while the system was armed in Night mode, the bedroom keypad starts to buzz and count down. Since I have had issues with the cats setting off my motions sensors, I waited until the countdown went to zero so that the sensor would be logged with the alarm. Except that the alarm did...

I appreciate all of the responses! I'm not sure sunlight caused the issue because is was poring raining that morning. Although, I do have a glass cocktail table directly inline between the window and the sensor. I could see where glare off that table could be an issue. The bracket is not...

Hello everyone, I have been installing an M1Gold system over the last couple weeks. So far I have had quite a blast installing the system. I installed two keypads, three motion sensors and a number of door contacts to test until I had additional $$$ to install more. Even with two cats, none...

Thankyou guys for your help! As suggested, I used ShieldsUP! to prove that port 80 and 21 are being blocked by my ISP. So I setup my router to take a different port and forward it as port 80 inside my network. So I just type URL:port and my router automatically forwards it as port 80 to the...

Hello everyone, I am in the middle of my first Elk M1G install and I am having issues with the M1EXP and port forwarding the internal web server. My router is setup to port 2601, 21, 26 and 80 to the IP of the M1EXP. I also have DDNS setup with a URL pointing to my WAN IP address. If I use a...