Recent content by CajunHAI

I am in the same boat.  I have a few switches that have gone bad and need to replace.  I will follow the above advice.  

I am in the same boat.  I have a few switches that have gone bad and need to replace.  I will follow the above advice.  

I am in the same boat.  I have a few switches that have gone bad and need to replace.  I will follow the above advice.  

Thanks everyone for the replies and assistance. My new PCS USB SIM seems to be working fine. 

Thanks everyone with for the replies.  My house has one main breaker panel outside, and two sub panels inside.  The main breaker outside does have a surge protector.  The two sub-panels have couplers.     I was looking into a repeater...question.  Do I need just one repeater at the main, or at...

Hi.  It's been a while since I've used Upstart in my home but had to get it up and running because I was having problems with some lights not working from my Leviton app.  I bought some new 35A00 switches but before replacing, I thought I would see what Upstart said about them.  The lights that...

Pete....good news.  I received my PCS USB PIM today and it works!  However, I got it connected via the USB PIM (virtual serial port), instead of the USB CIM (SIA), which is what the representative for Simply Automated told me.     Anyway, I'm connected and running!  whooo hooo   One thing...

Pete...I just ordered the PCS version of the USB.  I will give that a try.    Thanks! 

Pete...I just ordered the PCS version of the USB.  I will give that a try.    Thanks! 

Thanks everyone for the comments.  I have tried all of the above.  Since I posted my original question, the tech guy from Simply Automated contacted me and had the following reply.  "Since the UPB PIM uses USB 1.1 technology, and my computer has USB 3.1 ports, it will not work".     I find this...

Hi all.  I had the Upstart software working with my system via a USB interface with my computer but computer crashed and had to reinstall software.  I am having trouble getting Upstart to connect again.  I keep getting the red X next to Get Firmware Version with the message, "The powerline...

Thanks for the reply.  I am not aware of programming that I could do to reset the board?  I am familiar with lights, sensors, etc...but had no idea I can reset email board.  How would I do this?  What menu would this be under?   Thanks! 

Good morning all.  It seems that most folks have gotten over the whole SMTP thing, since Leviton stopped allowing gmail and yahoo.  However, I am still having the "reset" issue.  It seems that when I first installed the email notifier, it was reliable.  Over time, maybe 4-5 months, it became...