Recent content by CharlieGulf

Thank you gatchel, those look nice.

I prefer compression connectors as well, and should have used that term instead. Good point about changing out the keystone, I hadn't considered that, although I think it would be rare that I would need to do that on a coax cable. I’m mainly concerned about the quality of the signal, and...

Hi everyone. Sorry it’s been so long since my last post. I’ve been looking for some coax F connector keystones to complete the trim out of my structured wiring project in a new-construction home. I like the Leviton 40782-CPF, since they crimp directly to the cable. I assume this...

Great info and pictures Panamanian. I like that you can open the door a few inches, as I sometimes do that.

Very nice! I especially like the armored cable. Would love to see your setup, PMs on its way.

I like the clean look of cans too. I think I'll still go with a can for the alarm, but I don't think my communications runs (57 Cat 6 and 36 RG6) will fit, even in the two 42" Leviton cans I was planning on. Thus, I'm looking into racks, but that's another topic. I like the idea of the doorbell...

What's the benifit of that configuration? I hadn't thought about the doorbell or garage door switches. Good idea. What all can be done with the doorbell connected to the panel? I can understand plywood in an unfinished basement, but this is a mechanical room inside the living area of the...

I'd appreciate it if we could get back on topic. The only fire system I have is the 110v smoke detectors that the electrician installed for code compliance. What wiring and equipment would I need to monitor these with an alarm panel? I have a huge attic, so it's not a pain to put things where...

Dan, thank you for that link to the wiring guide. That should keep my busy for a while. Panamanian, thanks for that great list of tips. I appreciate you taking the time to post them all. It helps a lot. I'm planing to use the miniature stick-on contacts for that reason. I'm not comfortable...

I have a new home under construction, and I’m looking for some guidance in pre-wiring for an alarm/automation system. In the short term, I’m mainly interested in making sure all the wires are in the wall for alarm keypads, door/window contacts, etc. However, I was told it’s best to select a...