Recent content by Ckolin

I unhooked everything except for a keypad and defaulted the board and still can't connect to the panel. I also did a fresh install of RP on a computer that was new, had a serial port that was for sure working, and had nothing installed on it except windows and could not connect. You are right...

I was able to connect with this system before. It stopped being able after reconnecting all the sensors. I have tried another serial port on the same computer with the same results. I will have to bring in another system and try it. Also have tried a cable I know to work. Would this affect the...

I thought I had this licked. I was able to connect through the dial-up and get programing done except for the rules. Any time I try and send rules as a 'send all' or just rules the panel stops responding and disconnects. If anyone else has had this happen or can give me some suggestions please...

Update on connection problem. Still unable to direct connect with RS232 serial on the panel, but can connect and program through dial-up. Looks like the RS232 is bad. Tried difrent cables and no change. At least I can connect and program the panel remotely. Thanks for all the help everyone. If...

Thanks for the suggestion, however I have tried this and I still could not connect. As I am not a professional installer Elk Tech Support will not help. I need to find a local installer.

I tried using a diffrent serial cable and even tried a diffrent serial port on the computer (it is used on a diffrent system and was working before and after), still can't connect with ELKRP. When trying to connect the computer says the panel did not respond and cannot detect baud rate. Could...

I defaulted the M1 panel and am still not able to connect to it with ELKRP. Now when I try and connect it tries to connect and after 10 to 20 sec. of "detecting serial port settings" it comes back with the "System did not respond. Cannot detect baud rate settings.". I have checked the computer...

The access code is still 246801 in ELKRP and I rechecked the settings for the com port and all is as it should be. When I try and connect it says "detecting serial port settings" and then comes back after a few min. with "System did not repond. Cannot detect baud rate settings." and from the log...

Will defaulting the board wipe-out the rules already loaded?

I hope someone here can help. I have been assigned the task of setting up our ELK M1 gold and setting up the rules. This system untill I started working on it has never been tured on as far as I know. Here is our set-up (Elk M1G w/ Elk M1DBH data bus hub, connected to the hub are a keypad...