Recent content by cnacht

I am setting this up and have a couple questions hopefully someone can help me answer. First, I have telephone1 set to communicate through IP using the XEP to the central station. I want to use the uplink as telephone2 and use as backup. The drop down box for telephone 2 does not allow me to...

Yes, by driver I mean the G! driver. When you go to create a security communication device and have to pick a driver, I selected the Lantronics driver. When it asks me to put in an IP address, I put the XEP's ip address and port 2101. The connections are: G! to elan to RJ-45 to DB9 Male...

A follow up to see if this helps anyone. I have the M1XEP hooked up to my router and the XEP is connected to the M1G's com 0. I have an Elk ip232 connected to my HC 6 and to my router. I set my ip232 to act a client using the XEP's IP address and non secure port 2101. I set up the M1G in G...

Where do you get port 2101? The secure port is usually 2601 on the M1XEP. Are you setting it up to communicate with the non-secure port with that number? Also, do you do anything with the "incoming UDP packet data" box. Thanks, Chad

Can I connect to the M1G with RP through an XSP? If so then I can hook the G! Controller to com 0 then run RP through the XSP. If you meant run G! Through an XSP, I am not sure if that would work because the instructions specifically state it needs to be hooked to com 0.

This is probably one for Spanky, but if anybody has input, it would be appreciated. My elan G! controller is supposed to hook directly to the COM 0 port. Because of this, I am not able to connect my M1XEP to use RP over the network. From prior posts it may be possible to hook up my M1XEP on...

That was simple enough. Thanks for the help. Chad

I am using the ABN. In my log it says in the extended data "no code" (User 203) I have never set up a user 203 So it does not look like it is calling the central station. I was wondering if I could put something in the rule so it would. When I disarm using the keypad it says General(user 2)...

I have a rule on my MIG as follows Whenever the time is 530am AND area 1 is armed night Then Disarm Immediately. It works like it is supposed to but it does not send a disarm command to my alarm monitoring company, so it appears as though my alarm is still armed on their website. I use...

I created an account on my computer with all the user settings, keypads and zones along with rules using the elkrp software. I am trying to put this data on a usb drive to give to my installer to download to my M1G. I exported the account to the usb drive and when I import the file to another...

Thanks for the reply. Also, is there a difference in quality between resistors and what Wattage would I need in a resistor for the ELK M1G. Thanks again, Chad

I have a Elk M1G and was wondering where to get the 2.2k resistors. Worthington doesn't have them, neither does ADI. Thanks, Chad

It is starting to make more sense. Thanks. I am keeping the smoke detectors on separate power supply because if I powered them from the ELk panel my smokes wouldn't pass code. Apparently if I have the smokes connected to the elk panel I would have to use fire rated cable to the keypads and...

So it sounds like I would be better off using the 405-05 if I am using the elk-PD9HD powered by elk-P142 to provide power to the smokes. This way I would be relieving the M1G of any significant power requirements. What I still don't understand is what powers what and when. In a non-alarm...

Never thought of it like that. Although I am a DIYr and might not be stocking any extras. Are the supervised relays small enough to fit in the round gang box with the smoke detector. Chad