Recent content by comweb

I would like to move my HB solar sensor and AAG V3 wind instrument to a new location. It would require about 150' of Cat5 cable. I am supplying 12vdc to the solar sensor but no external power to the AAG wind. I am using a daisy-chain topology. Will this work? Will I have to supply external...

Eric, Finally got some time to add +12 volts DC to the solar sensor. I have been watching it on and off for the last 2 1/2 hours and so far so good. Yahoo! The readings seem very stable. I used +12V DC from the computer power supply and connected it to pin 7 on the RJ45 connector at the...

Eric, Thanks for the help. I probably won't try it till after the holidays as I am going out of town in a few days. Have a Merry Christmas and Happy New Year. Bill

Eric, I don't have any 1-wire power supplies. Can I use 12v DC from say a computer power supply? Bill

Thank you for your reply. The jumper on the solar board was removed. Certainly when the solar sensor was connected inside with the 3' cable and no AAG wind connected, there should have been enough power. Could I have a bad solar board? Bill

Eric, I recently purchased a solar w/RJ45 board and AAG wind from you. This is my first experience with 1-wire. I am using Weather Display to read the sensors. The solar sensor will, for example, be showing around 100mv reading and then go to 0 mv or 200mv occasionally. The conditions...