-
-
Ddwalt replied to the thread How many speakers can you install in M1.You need to not go below 4 ohm load on the speaker outputs. Per the note in the install manual: OUT 1 †† for speaker(s) ONLY (4 to 8...
-
Ddwalt replied to the thread Need help with extended range temp/humidity sensor.You have the 2 wire 2800. You attach directly to any zone. Please read the attached GRI instructions. When it senses water it needs...
-
Ddwalt replied to the thread HAI OP2 "NO CONTOLLER DATA".Thanks for the reply. Usually there is a yellow sheet in the box with the repair data. It usually lists the condition of the board as...
-
Ddwalt replied to the thread HAI OP2 "NO CONTOLLER DATA".Hi Bighorn, Did you save the RA paperwork from your repair? It would be interesting to know if they list the components replaced. My...
-
Ddwalt replied to the thread HAI Omnipro II serial connection.Hello Drtodd. You have either a serial cable or a ethernet cable. They are different. If it fits in the connectors on the top left of...
-
Ddwalt replied to the thread Need help with extended range temp/humidity sensor.Thats it...
-
Ddwalt replied to the thread Need help with extended range temp/humidity sensor.Thats it...
-
Ddwalt replied to the thread Need help with extended range temp/humidity sensor.Start by reading these 2 docs: You will be setting the jumper for 12 volt operation. Things to bear in mind. There is voltage on the...
-
Ddwalt replied to the thread Need help with extended range temp/humidity sensor.GeorgieC. Yes adding another power supply would be a good idea. You can add a GRI water sensor without using a resistor. On the HAI its...
-
Ddwalt replied to the thread Need help with extended range temp/humidity sensor.GeorgieC, 300 mA seems very high for a door sensor. That sounds like the maximum current spec not the idle current. Lets say 3 doors...
-
Ddwalt replied to the thread Need help with extended range temp/humidity sensor.Pete, You definitely were into security systems before me. In the 1980's I was working for HP and at home I was assembling my first...
-
Ddwalt replied to the thread Need help with extended range temp/humidity sensor.Pete, Sounders can be an issue but OP has 1 amp budget so should be ok. I always used the Moose MPI-47 inside as it was loud and being a...
-
Ddwalt replied to the thread Need help with extended range temp/humidity sensor.The exterior sounder has a separate current budget so we don't need to count it. There is a 1 amp budget for bell current. Don
-
Ddwalt replied to the thread Need help with extended range temp/humidity sensor.Pete, No argument from me. I would add since he has the software, He could use the export function to let us see his current config...
-
Ddwalt replied to the thread Need help with extended range temp/humidity sensor.Yes, the wording is not as clear as it could be. You do have the config saved away from your newer PC Access? It should be Upload to PC...
-
-
Loading…
-
Loading…