Recent content by firefly

Thanks.  I have not hooked it up yet to The Elk.  Was trying to get it working as a z-wave network first.  

Hi, based on this email thread, I am surprised that things may not of changed in a few years. Suggestions?   I have:   Leviton DZMX1-1LZ Linear WD500Z-1   Leviton VRUSB-1US Vizia RF + Installer tool USB (latest software checked) Leviton VRC0P-1LW Vizia RF + RS232 interface Elk M1XSLZW   ELK MG1...

Is anyone aware of an update to this manual that shows a slightly newer 364864-01 item with more dip switch's and configuration? I purchased this from Setnetpro 1.5 years ago and they still show a wrong picture. thanks

Thanks. Does the dimmer function work with the OnQ light dimmer switches too using the elk rules to adjust the percent?

Hi, I have almost the same problem. Have you solved it? I have tried much troubleshooting, even bought ONQ branchtech software. Their equipment works fine. Must be something with the ELK. thanks

Hi, no, I am using wired sensors. The problem is that I have not found any double hung locks that work well with standard sensors. I am hoping others have found a good combination. Conceptually they all could work, but I am looking for a clean installation. thanks.

Hi, working on my Elk system. Used an idea I found here to put both a mag sensor and plunger into a standard door lock. I can tell if its open or shut, and if locked or not. Great. Wish to do the same for my double hung windows. Easy to do the open and close with a mag sensor, any ideas how...

Just tried it again, this time from a different computer, and seemed to work fine. You do need to have a pdf reader though. Thanks for trying.

Hi, I could not find a wiring example for using relays and external power with the Elk M1. I know its probably obvious, but does this picture seem to work? I am using it at first to drive strobes doing different functions through rules. Could be cameras too. Look at the pdf at...