Recent content by highlyAuto

@ Mantorok,   Thanks for the tip. I can now turn my lights on and off with homekit which is awesome. Could I edit that zones list to isolate one zone at a time to figure out which zone is causing the issue? like add one at a time until i get the time outs?    @highlyauto

I was able to remove the thermostats so they don't show up on snaplink or in the plug in discovery. I removed Zone 15 by naming it "ZONE 15" and make it type auxiliary instead of temperature sensor and that seems to ignore it. I also removed a button that has never worked. I attached the log...

I had done the retrieve setup in snaplink. I hadn't done the force autodiscovery to true, but doing so didn't help. I noticed that the plug-in returns the thermostats in the list but [NotUsed]. I thought changing them from heat/cool to Not Used and then removing them from the "rooms" would...

Thanks for the encouragement. I was able to load the configuration into the account file which was great because I thought I was going to need to recreate everything without the original account file. I removed the thermostats from the setup and double checked that they don't show up in the...

Thanks anyways for the help. I downloaded the pc access software. However, it looks like I need the account file to edit my setup which I don't have since I inherited this system. I could start from scratch which is pretty overwhelming. 

@Mantorok   I attached the logs. In this case I tried turning on the kitchen lights. It's encouraging to be able to see the state of the lights atleast. Thank you.   -highlyauto

Hi @Mantorok,   Thanks for the update. I can see in the logs that 4 zones time out. It looks like it's stuck in a loop where it trying the problem zones, tries other zones, then comes back to the failed ones that time out and repeat. I can see bulbs on the home kit app and their current statuses...

Hi @Mantorok,   That's very kind. If you can't, then I will try to go into the PC access . I've been meaning to poke around with it anyhow.    Thanks

I'll try. I know this is not a plugin question, but is removing the sensor something I can do from the controller or does it require me removing the wiring from the panel?

The omni controller shows s/w version 4.0b when I go into setup- misc. It could be a faulty zone now that you mention it. I recently pulled out one of the HAI hai thermostats and replaced it with an Ecobee. It was preventing my A/C from switching to stage 2. All I did was tuck the controller...

Do you think there's an issue with a zone between 1 and 59 in that case? since I don't see a response? I attached the log. However it was too big so I deleted lines in the middle until I got it down to 150kb. 

Unfortunately, no I don't see that message in the log. I have 2000+ messages in the log file so I feel like it's not appropriate to paste them into the forum. There's no way to attach a file correct? I pasted the last four omni lines i see in the log below.   [03/08/2021, 19:06:46] [Omni]...

Hi @Mantorok,   Thank you for your quick response.    I am able to see that hte plugin was able to connect to the controller: TCP Connection: Open, but I do not see the "found" message. What could be preventing the found message?    Per your suggestion, I set forceAutoDiscovery to false and set...

I'm very new to home automation. The home I purchased had this system built in and I was able to set up their previous GUI using SnapLink but I would much prefer using homekit. This plug in seems to be exactly what I need, however, it is not discovery any of my system. I have switches...