Recent content by imfsimm

  1. I

    M1ZTS missing CAT 5 connector/Thermistor

    Nobody has any thoughts on this?
  2. I

    M1ZTS missing CAT 5 connector/Thermistor

    Hello Well after the move from California to Texas I discovered two things missing. The ELK-M1ZTS connector with the Thermistor in it. Does anybody know if these can be replaced without buying a new complete thermostat. I would not care if I had to buy the 7ft cables, although the little...
  3. I

    M1KP termination point

    That's why I love this forum, Thank you the ideas. I guess I wasn't thinking outside the box. Tim
  4. I

    M1KP termination point

    Talk about a senior moment!!!! that makes perfect sense now!. All I had in white was 22/4 laying around so I was thinking I could use that. But your right I need white 3 pair. I'm not sure I can find white 3 pair? Maybe some telephone wire? Thanks
  5. I

    M1KP termination point

    Hi I have a Elk M1 gold that I moved from my California house to my Texas house. I have the house wired now, getting ready to connect things. I have a M1DBH hub in the 28 inch Elk wiring panel, and two keypads. In the master bedroom I have to use a 6ft  piece of 4 conductor white wire because...
  6. I

    ElkRP 1.6.6 and Status Button Problem

    Spanky M1G can I knocked out the four holes in the top of the can for 3/4 inch and cut a hole to place the can inside the wall. I put four 3/4 inch tread to slip connectors on the can and tightened them with screw on nuts. I drilled four holes going into attic spaced the same as the holes on...
  7. I

    ElkRP 1.6.6 and Status Button Problem

    Toymaster I dont know why this is so hidden on the site, it should be attached to everything they have. Check the link I will try that "TestEmail" that is too easy. Crap, if one would stop and think about this stuffl It would then become obvious. ;) Ya! Right Thanks Tim...
  8. I

    ElkRP 1.6.6 and Status Button Problem

    Toymaster I too noticed that when I updated the software the first time. Did you do the three step process? Once I did that, it went to 1.1.2 Steve I was disconnected when I tried the email. I have a rule to send email whenever the keypad is disarmed, or my motion in the garage is tripped...
  9. I

    ElkRP 1.6.6 and Status Button Problem

    Hello All Has anybody else seen this? When I click on status button "ElkRP Ver 1.6.6" the Current Status and Remote Control box opens, it loads my zones ok. The Zone Status box scrolls to the bottom but I cant scroll up, when I try to grab the slider and pull it up, it goes right back to the...
  10. I

    elk +insteon

    Hello I too started having a problem with X10 lights flashing when a command was sent via a Plug and Power Desk controller. Then, I noticed I left '255 InsteonLinking' in the on position. :D I reset the system back to default and tried again, no more flashing lights. Tim
See more
Back
Top