RAL, The M1XRF2Hv2 Honeywell Protocol wireless receiver at the T2A5 type/address has logged 90 more data bus errors in the last 30 hours.
Thanks again for pointing me to that keypad menu. Wish I could see those data with the ELK-RP application.
I'll start where the receiver is centrally...
Any thoughts on what failure modes cause an Elk Honeywell Protocol wireless module to report "1141 = Expansion Module Trouble?"
Twice now, on 6 April at 22:07 hours, and on 1 June at 22:14 hours, my keypads started beeping and I shut the disarmed system down to make the noise stop.
Upon...
Thanks, RAL. I'll look into the 1290. But, Is it bad practice or may it possibly damage the ELK components to use a wet or GSM 12-Volt deep cycle battery in the hundreds of amp-hours and a, yes probably unsupervised, battery maintenance system for all my battery needs? That is, can the on-board...
I was locked out of posting as a newbie for a "day" while my new account settles out. Only one post / day for a bit it seems...
RAR, thanks for the tip about standby versus peak power requirements. I should have figured that out and it changes everything.
I've now redone my loads spreadsheet...
My inaugural post, thank you!
I'm considering replacing my end-of-life hardwired line-voltage smokes by adding smoke/CO sensor/sounders into my ELK-M1G system that currently does burglary and some Home Automation integration.
WRT smokes/CO I'm concerned about assuring at least the 24-hour...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.