Recent content by klims

  Thanks for the image. I have the same lights on my board :-( I followed this exactly when trying to resolve my issue a while back with no luck. Might be worth going through this process again now that I have plugged/replugged and adjusted my system. Thanks guys.

Could someone with a working XEP take a photo of the board with all the lights on? I'm wondering if there are any lights that should be on that are not, which might help me diagnose my problem

I've done a rough calc of the system when in normal operation(no siren) and the reg shouldn't be anywhere near overloaded. I have verified that all my network equipment is working as expected. It's definitely a problem on the XEP end

Hey guys, Thanks for the replies, unfortunately I am still not able to get my device to work. One last thought was the power supply to the unit. I'm powering the device from my home alarm which is putting out 13.9v. This is a little above the 12v recommendation in the manual. I figured it's...

  Unfortunately the "Find" feature does not work for me. This is the reason I am so far down the rabbit hole with this problem :blush:

Seeing as I changed the default RP access code using a serial connection directly to my PC, how would I go about connecting the M1XEP to the controller and giving it the updated access code if I can't connect to it over the network unless its connected to my controller?? I can't make sense of...

  Just tried this with no luck. My router doesn't show any connection info the the XEP even though I have seen the green light blink. Wireshark doesn't show any network traffic from the device either.       I have fully configured the controller in the ElkRP software including a new RP access code.

Thanks for the suggestions. I should have mentioned that I have tried all the suggested ways to connect via the ElkRP software including: ElkRP software with windows XP PC (also tried Windows 10 PC) M1XEP Diagnostics (1.1.0) from windows 10 PC M1XEP Update Utility from Windows XP   Can anyone...

Hi guys,    Long time reader, first time poster. I haven't found any posts that cover my particular issue so I'm hoping it's not a dead end...   I have an M1EZ8 security and home automation controller that I bought a little over a year ago that I've only just finished setting up. Now that it's...