Recent content by KNW247

Thank you all for your help. Here is the latest update.   I noticed that i had the ElkRP set to "Obtain DNS Automatically". I changed this to "Specify DNS Addresses to use" and my email is now working.

drvnbysound, There have been no changes to my ISP. I have my email account set up at Mydomain.com.  

Hi Mike, I started to download the new Firmware so I could use gmail, as the instructions indicate, however, while following the instructions to update the bootware, i got an error saying my xep was not connected. I then decided that since I "know" the issue is not related to an encripted email...

I could not find anything suggesting that port 25 was blocked. I did find a setting in my router that would send me email reports on my router that also uses port 25, so I turned that on, "just in case". That did not help. Since I have been using port 587, i forwared that port for the IP address...

My system was running great before I replaced my router, but now.... not so much. I can still access the system via eKeypad but the email stopped working. I know this is unrealated to the typical email issues because it was working before the Router changed and then it stopped. So Far, i have...

I recently created a rule in ISY to turn my back lights on for 5 minutes when my back door is opened at night. The main challenge was that i did not want the lights to keep coming on and going off when I am entertaining in the back yard. Sometimes, I want the lights to stay off (when sitting...

I am hoping that I have not bitten off more than I can chew with this install. I had zero trouble enrolling my wireless M1XRFEG and my PIR and Glass Shatter enrolled quickly, but now they are not working. The M1 says "transmitters not authorized". I hope that after I get the RP software...

Thank you. I was not using my shared Ground properly and thus was shorting out every other zone.   Thank you for your help. I see now that that was a silly error, but I just could not see the trees through the forrest.   Now my next question... How do you test a Hard Wired Glass break. I...

I'll bet that is my problem.

I got my Zone one working. This is the contact to my front door. When I move these wires over to zone two, it does not work. I am attaching a youtube video of my box.... The only two contacts I have hard wired are on zones 1 and 16. I have to bypass 8 of the 16 zones to the the system to work...

I just installed an M2 Gold but I am having an issue with the zones. I have placed 220 resistors accross each of the 16 zone terminals. Zone one has my installed door contact (which is working correctly). When the system does is self diognostic it tells me that I have 8 zones violated. The zones...