Recent content by LBeck

Thanks to clear the questions for me! I think I will "öpen" just one or two irrigation valves together (total = 8 valves) because the irrigation system depends of the pressure of the water gaved from 1HP pump. So two irrigation valves + 1HP 220v pump.

1.Thanks Frederic, 2. I intend to use the same power source that I will use with irrigation valves. (Transform power source = 24Vac - 1,2A - 60Hz Power = 30VA) 3. Contactor - Schneider LC1D093B7 Do you think that this contactor will be ok? (these numbers I don't understand so much!)   Main...

So, I understand that I can control a 1HP 220v pump using a contactor with 24VAC coil connected to M1RB relay? Am I right?

How many irrigation valve can be energized together from M1RB? Is it possible to conect the contactor (for pump) together considering that only one valve irrigation relay will be connected at time?

Thanks az1324, but in practice I understand that both (M1RB and M1XOVR) can be used for my propose - irrigation system. Sorry but I don't know so much about electronics ( I understand about computers ans electric). When you say that M1RB convert you mean that the relay close the circuit? If I am...

I have: Elk M1 Gold + M1RB + M1DBH + M1XOVR - not operating yet. I would like to automate my RainBird Valves from sprinkler system using ELK M1 and a 1HP water pump to work the system properly. Looking other questions and answers, I found how to connect the valves wires using M1RB and/or M1XOVR...