Recent content by linny

That's what I'm looking for. Sadly, I just order them a link last week-end I also found another solution. What I need to know is when the burner is on or off. I could put a light on the burner electric wire, and when the burner relay will be close, the light should be on. With the solar sensor...

yes and no I understand now how you detect if the system receive order to start, but unfortunatly with my configuration, that cannot work. My thermostat is connected to an electronic card, which do manage the docking fan. The fan is running at low speed all the time, and will go to high speed...

Out of curiousity, can you describe how you implement your HVAC monitoring. I do heat my house with fuel, and with the cost I think I will start monitoring closer. I'm curious about the hardware side, because it seems you manage it via windows, and I'm on the dark side of Linux. Thank for any...

Eric, thank for the quick reply I did attach to pin 4 and 5 I will continue to investigate tomorrow. If that doesn't work, I will order a new DS9097U I did test with a regular iButton attach to the DS9097U, without success I take note about the pressure device. I will definitly order case...

Hi I just receive my order today, and I have some questions and comment about it. - I order a hub, and there is 1 green leds ,ad 3 red leds I plug an 18V power supply 0.8A, and the green leds goes on. My question is , when do the red leds goes on. I did plug your pressure sensor and also...