Recent content by mcampbell

  1. M

    OPII not showing up in ATT gateway

    Figured it out. Just had to use my static IP of the panel without it showing up in my IP list. Kinda back door but it worked. Thanks
  2. M

    OPII not showing up in ATT gateway

    Unable to configure port forwarding due to panel not showing up on gateway. Can ping all day within the network and Snaplink works fine within the network. Anyone come across this?
  3. M

    Troubles on burg zones

    Thanks for the welcome. I appreciate your response as it helps me understand the values in the loop column of zone status. To elaborate a little. If I have a NC contact on my main panel with a resistor in series and I remove that resistor, should I not receive a trouble at my KP? This is with...
  4. M

    Troubles on burg zones

     Have had recent issues with troubles on multiple zones. Some zones are fire and I can attribute them to ongoing construction. (Dust, paint, etc.) I had taken this system over and realized after these troubles began happening that "zone resistors" was set to NO in PC Access. In talking to tech...
Back
Top