Recent content by michae1a1ee

I'm not getting that message because I can see I've already got 1.1.15.2 running. That might have been the first version I installed though, so I might not have gone through an update process at all.

Since I last wrote in this particular thread I've been able to get the Serial connection to the OP2 up and running with a different (an actual/proper) HAI 21A05 9-pin adapter, along with a Serial-to-USB adapter to a PC. I can now successfully connect to the board using a Serial connection in...

X10 via a XTB-IIR on my electrical panel.

Yes, HomeSeer displays the same behaviour in its Omni Plugin. I currently have a 10BaseT hub off the OP2 Ethernet port right now. For a short while I thought it was working better than the 100Mbps router I had in that spot previously, but now I'm not so sure either made any real difference...

Thanks @jlipsit that's useful to know. I still have the OmniLinkBridge installed and running, but honestly I find it goes offline too much of the time (OP2 ethernet port issue no doubt), so it's still not reliable. Sometimes I open Home Assistant and the Omni units/zones are available, other...

Hi All, I've searched through this entire site and read every post I found mentioning the Konnected.io company product offerings. I'm actually surprised that there isn't more discussion about them, or mention of their use. I'm curious if users on here have purchased Konnected boards/products...

Nope, I haven't done anything yet. If your suggestion is all I need to be able to disconnect the (non-activated) VOIP device completely, I'll do that and be done with it.

This morning I had my Omni Pro II beeping due to "Phone Line Failure". This is not the first time I've seen this. I actually removed my analog phone line that was connected to the system MANY years ago, and removed the lower cost VOIP replacement line (MagicJack most recently) not too long...

Thanks Pete. I'm already a multi-year user of HomeSeer and paid for the Omni Plugin right from the beginning. Both are working for me, but I'm investigating alternatives to HomeSeer as I think this is a prudent thing to do with their recent announcement of pricing changes. I fumbled my way...

Where I'm stuck at the moment is I've got the Bridge running, but when I go to Devices and pick OmniLink Bridge, this is all I see. I haven't configured the MQTT portion of the OmniLink Bridge Configuration settings. Is that the reason I don't see any Controls (Omni devices)? Is there a post...

This is all I see from the HACS left side menu. I think this may be a new change based on a message that had popped up - you need to search now, no browse option.

I've been stepping through this Home Assistant setup for OmniLink Bridge and I get the same screen for HACS as shown in Post #676. Although I wasn't able to get the screen that Pete shows, I was able to add the Repository by URL from the Add-On Store button. I've added OmniLink Bridge and and...

No need to answer - I sorted this out. Figured out that I had more than one copy of the PCA01.CFG file in my C:\Users folder structure due to Microsoft OneDrive. If anyone has ever installed the OneDrive backup you'll understand the headache this causes by relocating the user's personal...

I'm in a similar situation. I can't open my PCA file. I missed the security stamp prompt that came up and can't get it to come up again. I do have my pass phrase noted down but can't enter it. I've tried deleting the CFG file, no difference. Tried installing Dealer PC Access over top of the...

I've got a 100Mbps router between my main network and the OP2. I even set the WAN port on that 100Mbps router to 10Mbps. Sometimes from the 100Mbps router I use it's built in PING test to ping the OP2 successfully; other times even that test fails. The Ethernet port on the OP2 is so delicate...