Recent content by Redgecko

Thanks Pete, got things sorted. Not sure what went wrong but the detector was at fault, new Bosch one fitted and system all good again.

  Thank you again Pete, I'll check things out and see what I come up with. Appreciate your time and replies.

Pete thanks for the reply. What would I be looking for when testing the wiring? What else could the problem be if not the PIR. As I say it does activate the LED when there is movement but constantly displays not ready at the keypad.  Is this something I could use to initially see if another PIR...

Hi, need some help please. Have a wired motion sensor that is throwing a not ready code. Seems to be registering movement, LED flashes but I assume it's no longer communicating. Is it likely to be the sensor, I have no problems with any others in the house, and if so are there any readily...

Ok now things are working again, is there anything I can do to make things work with modern LED bulbs? Do I need to upgrade the switches and is so does anyone have a part # Is that why the one switch I pictured earlier is an HCM06? Thanks Ian.

Thanks Ral, that's the way I'll go then, this first used item was a gamble so would prefer that "New Item" confidence.

Thanks Ral, I would be happy to look into that unit, do you know if it's straight swap plug and play?

Thanks for the info Pete, I'll keep my eyes open. Switches seem fairly easy to find, the TW's not so much.

Ok an update,,,, Managed to find a used TW523 and took the gamble. Well it paid off, the unit works and fixed the problem, all lights back functioning as they should. Now it's a case of continuing to learn the system and I'll be looking to replace a few switches that look to have been...

Thanks for sticking with me so far.

Ok thanks Pete, I'll try some of these things out.  I have ordered a used TW 523 controller which I found on Ebay and I;ll try that first. If I get no joy I'll pick up a manual controller and test out the switches. I'll post back when I have some  results.

Yes I only have 2 keypads plugged in as far as I am aware and there is one lamp on next to the port and it is constant not flashing. Checked my automated switches and they have no dials, pics below. There are 8 of these (although some are linked 2 and 3 way) and they have a red LED at the bottom...

  Ok good to know on the controller. I don't know whether the panel is connected to the internet, certainly doesn't show in my network but that's wireless obviously. I have no mobile phone access either I'll grab a pic of the panel...

  Thanks for that idea but unfortunately I have no lamp or appliance modules.   Well I think the module may possibly have failed as I have nothing that is operating so it appears it is a case of all. The only thing that is receiving any communication is the Thermostat and, as that is an HAI...