Recent content by rhodges

I'm playing around with infinitude after not using it for a while. I noticed once I pointed my thermostat to it, I no longer get updates to carrier.  24 hours now and counting. I have tried a couple of different values in pass_req. I don't see any errors when I run it in debug mode. I see a lot...

2 thermostats, 1 system. There is a zone controller, which is really just a damper that shuts off the flow of air to all the ducts on a zone. When Zone 1 comes on, Zone 2 closes. If both zones "come on", then the damper opens and air flows in both (and it might ramp the fan up inside, it is a...

I'd like to give infinitive a go, but I have a 2 zoned system. How much guinea pigging would I need to be to get that working?

That's annoying. I paid enough for the thing, they should have hooked it up right. It is a dual speed outside unit. They had to run new copper to the outside of the unit. Seems lazy of them not to drop new wire at the same time then.

Yeah, I changed it back to my RT-AC68U (which has the latest Merlin firmware) and it is still working. I don't know if makes a difference, by my Asus is in bridge mode, it isn't acting as a router. I have a pfSense firewall setup.   One thing I notice is that I don't see values for...

Ugh. I too am using an Asus wifi access point. I guess I'll dig out the old one and give it a try. I verified myinfinitytouch.carrier.com was getting status updates until I pointed my thermostat at my pogo (the last was yesterday at 6pm my time). If that solves the issue, I would be very curious...

Thanks for the clearing that up.   In my state folder, I have README.md, changes, infinitude.json, started, sytems.json, and systems.xml   started has a number in it, sytems.json and sytems.xml are both empty   Does your thermostat show "Connected" on the main screen? - I'll have to check for...

I cannot seem to get this working on my pogo. I have it up and running. I can see the web interface, but the gauges are empty. It is acting like the thermostat is not calling the proxy.   I have inputted the correct ip address and port in the proxy settings of the thermostat. I verified I can...