Recent content by rs691919

As far as I know, they're the HAI HLC lighting controls.

Not sure what you mean by testing them...can you elaborate please? Thanks for replying!

Three of my lights stopped responding to commands from the Omni Pro board. LEDs are blue on all three. I tried reconfiguring using both the keypad and PC Access, but an error pops up saying No Module Found in Setup. The rest of the units in the house are working fine, just these three (which...

Switched the console out and the error still occurred. Changed the console address to 3, and the panel started sending the error to console 2 (in the master bedroom). So it would seem the error is at the panel or something to do with the wireless receiver.

I tried that. Didn't do anything different unfortunately.

I've seen several threads regarding this issue, but I wanted to revive the topic to see if anyone has a solution. I started getting the Button 333 message along with random beeps at one of my keypads throughout the day last weekend. I'm an end user, so my technical knowledge is limited, though...

    Thanks for the reply!  Well, apparently I was wrong and RTI is supposed to be able to recognize the light (and flag) status of HAI, as they are actually HLC links.  But for reasons that we do not know, HAI and RTI are not playing nice.  This is across the board with all feedback from the HAI...

Hello!  I've had an Omni IIe for quite a while now and was using iRule to control it.  With iRule going defunct, I decided to change my system to RTI and let my installer handle the technical aspects.  One thing we've noticed is that RTI cannot recognize state of the UPB links (which is...

OK, I'm following you both (thanks again!).  In my version, if the party is going on and the motion sensor is NOT READY for more than 15 minutes, then all of a sudden goes SECURE because of a break in the action, then the lights will go off.  Is that correct?   In neillt's version, the motion...

OK, I understand the idea of the Every 30 minutes command --- BUT, my understanding is that the "30 minutes" is divided up evenly over a 24 cycle.  Thus, if I happen to change the thermostat at minute 29, one minute later the program would change it back to the original heat setpoint.  Am I...

Thanks for the reply, neillt.  Being new to this (and not a programmer by trade), I probably don't understand the nuances.  Would the way that I had suggested not work for my application or is there a reason that your code would be better? 

I played around with those too, but I don't want the lights to turn on when the motion is triggered -- otherwise my son would run all over the house triggering lights just for the fun of it!  And if i use the timer as a trigger by itself, the lights will go off after 15 minutes even if someone...

I've played around with how to do it using flags, but I just can't make it work.  Any thoughts? 

Sorry for the slew of newbie questions.  I've tried to understand what "Buttons" are in PC Access and how they can be used.  Can anyone give a quick and simple primer so I can play around with it?  Thanks!

Ok, that makes sense.  So if I want to turn lights off when a room is not occupied for 15 min, would the following work:   1. When Dining Motion is NOT READY             Then turn Dining Timer on for 15 minutes 2. Every 1 minute              And if Dining Motion is Secure              And if...