Recent content by serodgers

Thank you for providing the serial header pin outs years ago. That allowed me to make my own serial cable instead of purchasing one. Sent from my iPad using Tapatalk

https://www.uplink.com/wp-content/uploads/2018/11/Uplink-5500EZ-Installation-and-User-Guide-4134647-Rev-2.pdf Para 3.3 about steps to activate unit serial for Elk. Despite the references to the micro USB port no USB connection is used . Same serial cable as previous uplinks units works...

Nothing at all. Just worked on phone with Alarm Relay and Uplink to activate unit and test. Drop in replacement for previous 4500 unit. Same serial header. Same message it outputs if Cellular service drops. Same Elk rules to alert me of Uplink drops service still work from my original Uplink...

Uplink 5500 AT&T version. Works great with Ek and monitored by Alarm Relay. Sent from my iPhone using Tapatalk

Will get into attic to get specifics. It had the same serial header as as previous unit. I used the existing serial cable to my Elk.

Works great. Sent from my iPad using Tapatalk

Uplink 5500EZ Att LtE model setup by Alarm Relay. Replaced the older 4500ez which got phased out. Sent from my iPad using Tapatalk

AmaZon. Recently replaced both my keypads when most of the lower leds failed. Sent from my iPhone using Tapatalk

Anybody else have a ELK-M1KP2 keypad with failed LEDs? Both of my keypads have a few failed leds mainly in the function keys. They are slowly failing one by one. Had them for 11 years. Seen a picture of a person with same issue on Amazon reviews or these keypads. Says they are surface mount...

I thought whever triggers were just what mode is selected. Not if it is in an actual running state. That why went with the relays to see when the fan or compressor or changeover valve for heat was called for and running. I have a TR-16 connected to my M1G but did not see where it would report...

No it uses a serial expander RS-232 connection. Sent from my iPad using Tapatalk

I use Elk M1G and HomeSeer Ultra plugin and have monitoring with Alam Relay via Uplink 5500ez cellular connection. Woks great and Alarm Relay was good on setup with Elk Panel and activating the Uplink unit. They upgraded my original 2500ez unit due to AT&T shutting down older 3G tech used in...

Sent from my iPad using Tapatalk

I have an Elk M1g with TR-16 thermostat. Connect with Homeseer HS4 now but same UltraM1G plugin as HS3. I added 4 24vac relays tapped into the thermostat outputs so i can monitor what it is doing and determine mode for events and other HA logic.

Uplink® 5500EZ connected via serial port on ELK-M1XSP Serial Port Expander. Alarm relay just sent me a upgraded ($100.00) one that is LTE AT&T due to the older 4500EZ 4G service model are going away. Works great and was plug n play compatible with older uplink. Sent from my iPad using Tapatalk