Recent content by sparkyman

If there is a better way to do this I'm open to suggestions  being a newbie and all my programming knowledge is primitive and simplistic in nature . And i can use all the help i can get. Thanks

Using a UMI module to run gate access  does anyone have some programming they would like to share  want to use output 2 for operation and input 2 for status of gate for controlling timed close and open

Thought i had it all worked out but back to being a newbie I was wrong thought if I took a dry set of contacts mounted on the gate and sent as an input to the umi  i could see status of weather or not the gate was closed so i could open or close and turn on driveway lights automatically  but the...

thanks for all your help as it turns out i had momentary contacts set on output 1 and i was programming on output 2  NEWBIE mistake i guess Got everything working now off Omni II now i can start building the operating program for what i all want it to do

is there some way to pulse the out put for 2 second  i am trying to use it to activate my gate controller just need a momentary contact

yes i got it working on the UPB network and i now have it working a bit on the omni having problem writing the program to only have the out put on for two seconds

Sorry I've been away at work and unable to get back to programming Still can't get it to work  not sure what I'm doing wrong except that I'm a new be to programming and it takes a long time to figure this out without a manual on programming Is there somewhere i can go to on the internet for step...

How can i program with PC Access input info shows up on key pad but no operation Im trying to use one of the outputs to open and close gate any ideas on programming

i am trying to use the auto config on the op11and letting it try to find the module

Need some help got a umi module for my gate control but HAI system won't see the module in Config. used upstart to program module but when i try to config to HAI it come up as unknown module any ideas would be helpful as i am new to a lot of the programming and have just been getting by by trial...

how can i setup my omnipro II to be monitored by an internet monitoring company they asked me what protocol it comunicates in can anyone help me with this question

I just bought some modules to replace the X10 modules that i have running in my HAI system as they were not working properly and i cant get them to program . I put the module in setup mode but the Omni pro II doesnt find them keeps coming up unknown device. I do have a upb rain 8 running in the...

thanks for the info I will have too order some and try them

I contacted HAI and the answer I got from them was that the dimmer switch made by them is not compatible with led bulbs , guess i will have to try a different supplier for the switches any suggestions.

i will look into the manufactures list to see if they are on the list thanks for the info