Recent content by Spuds

I've also had good luck with the PCS switches, I've found them to be very good quality.  They have a few more config parameters available, via UPStart, then Leviton (for example the sensitivity setting which can help significantly if you have any noise on the line and the brightness of the...

Did you "factory reset" them to be sure there is no configuration issues that may be causing you issues.    I've honestly never had a UPB switch fail to manually work (unless it was wired wrong), I've had a few stop responding to UPB signals, but those were all in service for many many years and...

X10 it is then ;)

Just to close this out, the old SA ZPCI-B was indeed a dud ... replacing it with a new phase coupler fixed the strange behavior that I outlined.    With the working one in place I do see a slight signal loss on the "same" leg and an increase of signal on the "other".  The loss is minimal and...

I run a few forums so I'm pretty familiar with spam bots and spam in general, and whats involved in a generally thankless job.  That said I wanted to provide some feedback.   The current protection on this site is to only allow a new member to post once per 24hrs and then after a post count...

Thanks, that pretty much sums it up :D

I know the Omni supports Radio RA2 but I have not been able to determine if that includes support for the RA2 Select equipment as well.  Hopping someone knows for sure.

Thanks for the responses, I would have replied this AM but I'm still in the restricted box.     Thanks for the clarification on the couplers = no generational bias, I'm going to assume its just gone "bad" and get a new one to try.  I'll probably get a PCS PPC-1 and see how that performs.    ...

My main panel is in the house, it has a 100Amp breaker that feeds a sub panel in a detached garage.  I installed a SA ZPCI-B in the garage breaker box, the lights on the ZPCI-B show normal operation.  Of note is that particular ZPCI-B is from around 2005.   I was setting up some new PCS UPB...