Recent content by tckeiter

  Right, and I guess I actually would not even need to check if the output is off in the rule since I always want it on during these time periods.   WHENEVER "every X minutes" time is "later than 7am" and time is "earlier than 5pm" then turn it on for the daytime   I could try the above if the...

Oh ok... So instead of doing a timed rule break it into 3 rules. 1)Tell the outputs to turn on in the morning at set time mon - Fri. 2) Write a rule that checks every minute or so if those outputs are on and if not turn them on 3) Turn off the outputs at set time at end of day. It may take more...

Yes, the P1215K and M1's negative terminals are connected and yes the problem occurred in the same manner whether being powered by the M1 directly or the newer P215K. No, it did not always happen. It has only been the last 1 1/2 years or so but it was installed about 4 years ago. I agree that it...

What is unique to these 3 doors is that they run off a timed rule. None of the other doors on the system have a rule to keep them open during business hours because they are not common doors. The rule is triggered Monday - Friday at 8:00 am and output stays on for 10 hours. This part works...

The outputs are triggered from the m1 panel which then triggers the relay on each door module. No output expander connected to the system. I assume then that the outputs are powered by the panel but each door module is on the P215K. The P215K is brand new with new battery. I moved all the data...

The rule just triggers 3 different outputs to open for 10 hours Monday - Friday. We have never seen the rule not trigger since the random locking only happens midday and the doors were open prior to the failure. We try to check the doors by swiping them immediately after it is reported and the...

We have an Elk-M1 gold installed with 15 Elk-M1kam door modules. They control various access doors and gates throughout the property. There is a series of rules which unlocks 3 doors Monday - Friday for about 10 hours each. This rule works without issue 95% of the time. Every other month or so...

Thank you DELInstallations! You were spot on about the REX circuit in my test environment. I was able to jump the REX which fixed the Form C relay being stuck in the open position. It is one of those things that makes perfect sense now but I needed a little push to see it. I sincerely appreciate...

I did not haveof the RTE request to exit jumped. I just tried a 2200 ohm resistor from the RTE to the NEG. That had no effect. I also tried jumping the door switch terminal to the NEG but also no effect. tried to connect a volt meter but do not get any reading from the relay terminals. I could...

Apparently you can't paste a screen shot to this forum. Anyway, I have a 24 vdc power supply and havinig the + connected to the COM terminal. I have the - connected to one wire of the maglock and the 2nd wire of maglock is connected to the N/O terminal of the access module.

Sorry but the wiring diagram didn't paste correctly first time.

Ok, the rule I am using to test is: WHENEVER ACCESS Access Module (KP 2) is TRIGGERED THEN TURN Output 194 ON FOR 5 SECS and the wiring diagram: The weird thing is that when I connect it this way the maglock receives power when the Elk is powered on but does not receive power when I...

I was wondering if anyone out there has any experience with the ELKM1KAM door access module? I am having trouble triggering the form C relay on this board. The module is set to address 2 so output 194 should be what is turned on and off. Problem is that relay will not trigger. Any suggestions...