Recent content by tparvais

is there an specific URL to write string a line 1 and line 2 of the LCD ?   Could be useful to send display from another device to the WC32 LCD

  that's the idea: display on LCD the IP@ configured (statically/dynamically DHCP) of WC board.  could be via PLC specific command or why not de facto in bootloader, display it few seconds without specific PLC code   Thomas

      Living in Belgium... I'm afraid with taxes... When I ordered these boards several years ago, I paid them twice...   Thank you in any case !

  hello   can you summarize which hack should I do on WC8 HW V2.2.2 and WC32 HW V5 to improve behaviour (stability + non saturation) ? thanks

to display it on the LCD   Thank you

  Hello   I've tried to connect my Rev 2.2.2. Firmware is v03.02.15 so I think impossible to upgrade locally... :-(   My WC32 is HW REv5. I think it is a beta board... there are small red wire added manually.   SW  v04.02.00. I succeed to upgrade to 4.02.19.   I had for both to do a factory...

  I have a spare WC8 Rev 2.2.2 and a spare WC32 Rev5.0 (beta I think...)   Are they better ??   Thank you   Thomas

I've Board 2.0.2. I've already changed the HiH4000. does not help. Possible to tell me where exactly should I install capacity (value ? between data pin & GND i presume ) and extra resistor ?   Thank you

  Hello   indeed, this is a Rev 2.0.2 board. What should I do ?   Thank you   Thomas

Hello Strangely, this problem is back, on my WC8. Do you have a electtronic scheme showing how the HH4000 is conenctected to CPU ?   Thomas

Hello This is v03.00.07   it works with a unique DS18B20. but sometimes, it works also with the ones that make IP down   what is the link between TCP/IP and DS18B20 ?   Tx

Hello   since some times, my WC8 didn't connect anymore with my router. Can't ping, Can't browse admin page   On ethernet port, status leds are blinking, seems to have a Layer-1 active link.   If I disconnect my 1-wire DS1820, it works.   Any idea ?   Thank you   Thomas

http://admin:[email protected]/api/status.xml   This works. Thanks !

Hello Is it possible to read via URL GET value of VAR1 ? I've a piece of code that make some tests and set VAR1 according AIP1 value   I cannot find this   WB8 - FW V 3.00.7   thank you

  Hi   what do you mean ? I use very small Solid state relay to launch small pulse to my fan speed control, which is controlled by a small HF module. with these relays, I simulate the pressure of the radio buttton switch   I do not have more details, feel free to as kfor any questions