Did you get your set up and running. I’ve been using Homebridge for years and thought I would try Home Assistant and got this up and running in a couple hours on a raspberry Pi 5. Configuration of the mqtt link was somewhat confusing . But I am up and running now.
The question I have is that...
I have two connect sensors on gates that beep my keypad when they are opened so i know someone is coming into the yard. I am now using yolink for another gate that is very far away. Yolink notifies me when that gate is open. I would like to find a way for it (or HomeKit) to send a request...
Under Temperature sensors in PC access
Action type is Temperature High and low points are 0
its connected to the main board not an extension
Under Status control it is #88 Temperature sensors
Don't know what else to do.
i just changed out an older temperature sensor with a new 31A00-7 Extended Range Temperature sensor. it should be about 76 outside or so but the sensor says 106. This is a three wire connection as was the previous one. Ant thoughts on why it would not register the right temperature. In PC...
I am sad to say, that I get to join this thread as well as my system is also doing this. I do have a lot of things on our local area network, too many things to debug a bad packet. Plus new consuls are no longer available. As I read through the thread there seems to be lots of different things...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.