Coax is 5X diameter minimum, with a "perfect world" being 10X (never happens or is practical). Maximum number of bends can add up to 360 degrees or 4 90's before you need to put in a pull box.NeverDie said:I'll assume the minimum bend radius of RG6U is 3 inches. So probably 45's instead of 90's. Probably necessary for pulling anyway. Or, for pulling purposes, should I use 22.5's?
I'll assume blue solvent welds instead of primed. Goes much faster!
Most of the times the conduit can be put in with only 2 90's. Grey pipe flexes significantly and can be "flexed" around a lot of obstacles. You're better off heating and slightly bending instead of installing fittings.