HA7NET compatible with all Hobby-board module & AAG weather station ?

[tparvais]

Hello

I'd like to know if the Bus master 1-Wire/Ethernet HA7NET is compatible with all HB sensors (including lightining, double counter, HVAC, pressure, humidity...) and also with the AAG weatherstation V3 (airvane + speed meter)

Will it provide also extra power for non parasitic mode ?

May be it's more easy to use this bus master than USB and OWFS.

Thank you


Thomas

 

[ericvic]

Thomas,

If the HA7Net supports reading all 1-Wire chips then it would be compatible. I don't know about it providing external power.

Eric

 

[jaysonc]

It provides 200mA on each of the 3 1-wire ports.

I am using a pair of HA7Net with the hobby boards sensors for my weather station.

The HA7Net can support any 1-wire sensor. It has built in convenience features for some devices, and low level 1-wire interface for everything else.

--
Jayson

 

[tparvais]

Eric,

question was about providing +15V DC for Barometer i.e. via the RJ-45 ? compatible ?

Thomas

 

[jaysonc]

No. It does not provide +15VDC. I am using the HB injector for my Barometer.

--
Jayson

Eric,

question was about providing +15V DC for Barometer i.e. via the RJ-45 ? compatible ?

Thomas

 

[tparvais]

No. It does not provide +15VDC. I am using the HB injector for my Barometer.

this means that cabling is compatible between both systems ? (injection by injector won't cause issue on ha7net ?)

 

[ericvic]

No. It does not provide +15VDC. I am using the HB injector for my Barometer.

this means that cabling is compatible between both systems ? (injection by injector won't cause issue on ha7net ?)

The Power Injector doesn't provide power upstream, it only provides power to devices attached to the "out" port. I don't know the HA7Net pinout but the only thing you would need to worry about is to make sure that the data and ground lines match between them.

Eric