mikeindustries
New Member
I'm not sure if this started happening right after the 3.10a firmware update or not, but none of my audio zone information updates anymore on my HAI OmniPro II. I can still successfully send commands like On, Off, Volume, etc to the Russound units, and they respond, but their status never updates on the HAI anymore. Basically, two zones are stuck showing On (even though they are off) and the rest are stuck showing Off.
So far, I have power cycled the entire house, unplugged the networking on the Russound stuff and replugged, and also re-uploaded the setup to the OmniPro II. Nothing.
Any ideas? What part of the system is actually sending the two On statuses? Seems weirder than if everything was stuck on Off.
So far, I have power cycled the entire house, unplugged the networking on the Russound stuff and replugged, and also re-uploaded the setup to the OmniPro II. Nothing.
Any ideas? What part of the system is actually sending the two On statuses? Seems weirder than if everything was stuck on Off.
