damage
Senior Member
Damage,
So now to catch up. Are the following steps OK?
1 - Lamp server created sitting to the side and online
2 - Install XPL hub, XPL Logger and Sender on Infocast; validate that it runs on reboot and with DCM
3 - Install Python on Infocast
Thinking also of utilizing XAP with your TS setup.
thanks for the info on copying the sd. i suspect i'll be needing to do that at some point.
1 - fine
2 - you'll just need to start the hub on reboot. the logger's only useful if you're sitting at a shell, but is a good test to make sure the infocast is receiving xPL messages. the sender will just be run on an as need basis. you can test it out by sending a message and seeing if it shows up in DCM.
3 - after installing python you can install my script linked above & set it up to run @ boot. then you can control things on the infocast remotely via xPL.