BulletHead
Member
I have the following for my Elk M1G with hardwired smokes and COs. At the time I was in the middle of gutting/re-framing the house, I totally overlooked hard wiring for the window sensors or for glass break sensors. So now I want to add a few GE NX-488 glass break sensors and also an Uplink 2500 for primary communication (I have IP monitoring currently via AlarmRelay (no POTS)), is this what I would need?
I may add other wireless devices like camera, etc.
Currently Installed Elk M1G:
M1Gsys4s with M1KP2
1280 8Ah battery
M1XEP ethernet module
GE-ESL541NCSXTE smoke detectors (built-in relay, sounder) (qty 6)
GE-ESL250-CO CO detectors (qty 3)
GE-ESL405-03 polarity reversing module
VIS-VI-PET pet tolerant motion (qty 2)
GRI-GRIRB01T-W roller ball for entry door (qty 1)
Add-ons desired/needed:
M1XRFEG wireless receiver
GE NX488 glass break sensors (qty 5)
P983 power supply with can
M1DBH Data bus hub
W018B RS485 cable (from DBH to M1G panel)
Uplink 2500
M1XSP serial port expander
W046A serial cable (M1XSP to Uplink 2500)
1208J2 battery
TRG1640 transformer
Am I missing something?
I may add other wireless devices like camera, etc.
Currently Installed Elk M1G:
M1Gsys4s with M1KP2
1280 8Ah battery
M1XEP ethernet module
GE-ESL541NCSXTE smoke detectors (built-in relay, sounder) (qty 6)
GE-ESL250-CO CO detectors (qty 3)
GE-ESL405-03 polarity reversing module
VIS-VI-PET pet tolerant motion (qty 2)
GRI-GRIRB01T-W roller ball for entry door (qty 1)
Add-ons desired/needed:
M1XRFEG wireless receiver
GE NX488 glass break sensors (qty 5)
P983 power supply with can
M1DBH Data bus hub
W018B RS485 cable (from DBH to M1G panel)
Uplink 2500
M1XSP serial port expander
W046A serial cable (M1XSP to Uplink 2500)
1208J2 battery
TRG1640 transformer
Am I missing something?