From the AquaConnect documentation for a AQ-CO-SERIAL, i believe my Pro-Link command to perofrm a button Press and Release of the "Lights" button is as follows:
Message 1 sent out HAI Serial Port - ^P^B^H^I^@^\^P^C
Message 2 Sent out Serial Port - ^P^B^B^|^@^]^P^C
(FYI - those are actually 4 messages as Prolink can only by 15 characters)
I derived via the following:
DLE STX CMD DATA Checksum DLE ETX
Example (Release < key)
10H 02H 02H 01H 00H 15H 10H 03H
A 2 2 1 0 F A 3
Press Lights
10H 02H 01H 09H 00H 1CH 10H 03H
^P ^B ^H ^I ^@ ^\ ^P ^C
^P^B^H^I^@^\^P^C
Release Lights
10H 02H 02H 09H 00H 1DH 10H 03H
^P ^B ^B ^| ^@ ^] ^P ^C
^P^B^B^|^@^]^P^C
Can anybody confirm if I am going down the right path?
Message 1 sent out HAI Serial Port - ^P^B^H^I^@^\^P^C
Message 2 Sent out Serial Port - ^P^B^B^|^@^]^P^C
(FYI - those are actually 4 messages as Prolink can only by 15 characters)
I derived via the following:
DLE STX CMD DATA Checksum DLE ETX
Example (Release < key)
10H 02H 02H 01H 00H 15H 10H 03H
A 2 2 1 0 F A 3
Press Lights
10H 02H 01H 09H 00H 1CH 10H 03H
^P ^B ^H ^I ^@ ^\ ^P ^C
^P^B^H^I^@^\^P^C
Release Lights
10H 02H 02H 09H 00H 1DH 10H 03H
^P ^B ^B ^| ^@ ^] ^P ^C
^P^B^B^|^@^]^P^C
Can anybody confirm if I am going down the right path?