Omnistat cool setpoint changes on its own???

[stev398]

I have an Omnipro II setup including 4 omnistat thermostats. I’ve been having a problem that the cool setupoint on one of the omnistat thermostats changes to 85 degrees at apparently random times. Nowhere within my programming do I have a line in which I set the cool setpoint to 85. Any clue why this is happening?

 

[ASIHome]

Make sure the internal schedule is turned OFF. This usally happens when it is set to on. What model thermostat are you using?

 

[stev398]

My thermostats are RC80s. How do I change (turn on/off) or check the status of the internal schedule on an RC80.

My configuration is as follows:
1 x OmniPro II (firmware upgraded to 3.1 about a month ago)
1 x Omni Pro II Expansion Enclosure
1 x Omni Pro II Expansion Module
1 x LCD Console for HAI Omni Controllers w/ Speaker/MIC
2 x Omni Touch Screen Controllers
2 x Flush Mount Speaker/Microphone Module
1 x External Extended Range Temperature Sensor
2 x Indoor Flush Mount Temperature Sensor
4 x Omnistat Heat/Cool Thermostat (RC80)
4 x RC80B Relay Isolation Module (on each thermostat)
Integrated with Lightolier Compose PLC lighting System

 

[ASIHome]

To turn off the internal schedule:

Make sure the stat is in Mode OFF

Press: Prog, Prog, Prog, Fan

Use the the Right arrow to move to location 3 (03 will appear in the upper right corner of your display)

Use the up/down arrows to change the value to 5 (large blinking number in the center of your display)

Press Fan to exit.