I am replacing an old Brinks BHS-2000D based system that uses wired and wireless sensors and evaluating what I can reuse for a replacement system which is likely to be Vista20P or Vista21iP based. I am only interested in alarm and fire, no interest in IoT/control. I will be trashing the panel, keypads and 4-wire smoke. This leaves the following:
Thanks
John
- 3x SpreadNet wireless SN-935DT DualTec motion sensors
- 2x SpreadNet wireless door sensors
- 1x SN914-SZR Spreadnet receiver. I don't have an SN-900 Prog programmer but these crop up on eBay occasionally if I need one.
- 4x wired DT-435TB DualTec motion sensors (need to check for EOLR but this was after-market install)
- 2x wired external door sensors
- 1x overhead garage door sensor
Thanks
John