jon102034050
Active Member
Hey guys - I recently came across some free aprilaire thermostat stuff and have decided that it's time to get rid of my unreliable zwave thermostats and integrate my single stage heating/cooling 3 zone setup with my Elk. Attached is a drawing of my understanding of how my setup will be wired. So far, I have the following components:
aprilaire 8811 - protocol adapter
aprilaire 8818 - distribution panel
aprilaire 8870 (3x) - thermostat
aprilaire 8061 (3x) - remote temp support module
aprilaire 8051 (3x) - remote flush mount temp sensors
aprilaire 6203 - 3 zone, single stage controller
elk m1xsp
elk m1dbh
What I'm looking for is some validation that my understanding of how this is drawn out is correct, and if not, what else is required or should I change
Thanks all!
aprilaire 8811 - protocol adapter
aprilaire 8818 - distribution panel
aprilaire 8870 (3x) - thermostat
aprilaire 8061 (3x) - remote temp support module
aprilaire 8051 (3x) - remote flush mount temp sensors
aprilaire 6203 - 3 zone, single stage controller
elk m1xsp
elk m1dbh
What I'm looking for is some validation that my understanding of how this is drawn out is correct, and if not, what else is required or should I change
Thanks all!
