Hi all,
My Elk was speaking, including zone changes, just fine. I took it offline to relocate it, got distracted and the M1G sat in my office disconnected for about a year. I hooked it up again. Now my Elk is speaking in the sense that if I "Send and Say", then the Elk dutifully announces "Front Door Open" (or whatever). However, when I open/close said door, she's silent... (No voice.) I do get the keypad chime acknowledging the zone change and (of course) the keypad recognizes the zone change too. This behavior is consistent across all zones.
Globals -> Output 1: all volumes are set to 7.
Globals -> Voice: all voice items are enabled.
Zone ### -> Definition: 01, Type: 0, Atrributes: Bypassable = enabled, Enable chime = enabled, all other Attributes are disabled.
Rules: none (I'm new! )
Any ideas on why she's giving me the silent treatment worse than a ticked off 12 year old when I open/close a zone? Thanks!
My Elk was speaking, including zone changes, just fine. I took it offline to relocate it, got distracted and the M1G sat in my office disconnected for about a year. I hooked it up again. Now my Elk is speaking in the sense that if I "Send and Say", then the Elk dutifully announces "Front Door Open" (or whatever). However, when I open/close said door, she's silent... (No voice.) I do get the keypad chime acknowledging the zone change and (of course) the keypad recognizes the zone change too. This behavior is consistent across all zones.
Globals -> Output 1: all volumes are set to 7.
Globals -> Voice: all voice items are enabled.
Zone ### -> Definition: 01, Type: 0, Atrributes: Bypassable = enabled, Enable chime = enabled, all other Attributes are disabled.
Rules: none (I'm new! )
Any ideas on why she's giving me the silent treatment worse than a ticked off 12 year old when I open/close a zone? Thanks!