I had three reed door switches in serial connected to zone 1. Everything worked fine.
I recently seperated them into individual zone connections. 1, 2 ,3 etc. 1 for each door. However only zone 1 works. If I check the switches with a ohm meter I have a continuity at the panel on each switch. When plugged into the board, the board shows 13.7 volts at zones 2 and 3 but zone 1 shows shorted and works as it did before.
What am I missing? The zones are configured identically.
Thanks,
Clay
I recently seperated them into individual zone connections. 1, 2 ,3 etc. 1 for each door. However only zone 1 works. If I check the switches with a ohm meter I have a continuity at the panel on each switch. When plugged into the board, the board shows 13.7 volts at zones 2 and 3 but zone 1 shows shorted and works as it did before.
What am I missing? The zones are configured identically.
Thanks,
Clay